Canon MF633C/632C/631C error E015

E015-0000— Error in Main Motor
Detection Description The engine detected an error in the Main Motor.

Remedy1. Check the harnesses/connectors connecting the Developing HP Switch and the Engine
Controller PCB.

2. Check the harnesses/connectors connecting the Developing Separation Solenoid and the
Engine Controller PCB.
3. Replace the Main Motor.
4. Replace the Engine Controller PCB.
5. If the symptom persists after replacing the Engine Controller PCB, the Developing HP Switch,
Developing Separation Solenoid or Main Drive Assembly can be causing the problem. Remedy:
Contact the service office of corresponding sales company.
E015-0001— Cassette 1 lift-up error
Detection Description A rotation detection signal was not detected within the specified period of time after the Pickup
Motor of the cassette of the host machine was driven.

Remedy1. Check the harness/connector between the Engine Controller PCB and the Pickup Motor of the
cassette of the host machine.

2. Check the condition of the gear at the host machine side (missing teeth, swing).
3. Replace the Pickup Motor of the cassette of the host machine.
4. Replace the Engine Controller PCB.
E015-0002— Cassette 2 lift-up error
Detection Description After lift-up of the Lifting Plate of the 1-Cassette Unit started, ON status of the Lifter Sensor of the
1-Cassette Unit was not detected within the specified period of time.
Remedy 1. While the cassette of the 1-Cassette Unit is removed, turn ON the power and insert the cassette,
then check the operation sound of the motor.
When there is operation sound of the motor, check if the Lifting Plate has been lifted up.
When the Lifting Plate has been lifted up:
1-1. Check that the Lifter Sensor of the Cassette Unit is properly installed.
1-2. Check the harness/connector between the Engine Controller PCB and the Lifter Sensor.
1-3. Replace the Lifter Sensor.
1-4. Replace the Cassette Driver PCB.
1-5. Replace the Engine Controller PCB.
When the Lifting Plate has not been lifted up:
2-1. Check the condition of the gear of the Cassette Unit (missing teeth, swing).
2-2. Check the harness/connector between the Engine Controller PCB and the Lifter Solenoid of
the Cassette Unit.
2-3. Replace the Lifter Solenoid.
2-4. Replace the Pickup Motor of the Cassette Unit.
2-5. Replace the Cassette Driver PCB.
2-6. Replace the Engine Controller PCB.
When there is no operation sound of the motor, check the followings:
3-1. Check the harness/connector between the Engine Controller PCB and the Pickup Motor of
the Cassette Unit.
3-2. Check the condition of the gear at the Cassette Unit side (missing teeth, swing).
3-3. Replace the Pickup Motor.
3-4. Replace the Cassette Driver PCB.
3-5. Replace the Engine Controller PCB

Добавить комментарий

Ваш адрес email не будет опубликован. Обязательные поля помечены *